Can the DIGIWAY Spring Return be used manually?

Can the DIGIWAY Spring Return be used manually?

The DIGIWAY Spring Return is usually in semi-automatic mode. This means it works as:

  1. Power open (when triggered to open)
  2. OR manually push open
  3. THEN spring close.
If users push through the door, it puts tension on the spring mechanism and does not cause damage like it could with a fully automatic door operator.


The DIGIWAY Spring Return can be set to fully automatic mode where the motor assists opening and closing. This setup would negate the protection you get from semi-automatic mode. It also isn’t suitable for manual use due to potential damage to the motor if abused by users forcing through the door.  

Fully automatic mode is ideal for access controlled pressurised rooms.


For more information about the DIGIWAY Spring Return, visit the CDVI website. 



    • Related Articles

    • DIGIWAY Spring Return normal operation troubleshooting

      The door isn't operating when triggered Check the door's operation by using the direct open command. Make sure you exit the menu then use the bottom button to immediately trigger an open command. Alternatively, use the radio fob (once it has been ...

    • Can the DIGIWAY Plus be used manually?

      No. The DIGIWAY Plus is a fully automatic door operator for swing doors. This means it powers open and powers closed. The door should not be used manually. If the door is required to be used manually, then the DIGIWAY Spring Return door operator ...

    • DIGIWAY Spring Return auto-calibration troubleshooting

      General advice for setting up Fit the unit and arm as per the diagrams in the installation manual. The door must be completely free swinging with a physically defined close point - i.e. not a swing-through door. Any hydraulic or spring closing/hold ...

    • Does the DIGIWAY Spring Return hold the door locked?

      The DIGIWAY SR door operator does not hold the door locked. It provides 12Vdc 1A and a full relay through which you can incorporate an electronic lock.

    • DIGIWAY Plus auto-calibration troubleshooting

      General advice for setting up Fit the unit and arm as per the diagrams in the installation manual. The door must be completely free swinging with a physically defined close point - i.e. not a swing-through door. To begin with, keep the setup as basic ...