How to set door limits | DIGIWAY Door Automation

How do I set the door limits?



Warning
To correctly auto-calibrate the DIGIWAY, first you need to set the spring pre-load tension. 
Idea
For instructions for the full calibration process, see this article. 
Once the spring pre-load tension is set, you can set the door limits by following these steps: 
  1. Open the DIGIWAY app and find the correct unit that you want to programme.
  2. Hold down OK to enter the programming menu.
  3. From the menu, select Door Calibration.
  4. Switch the door to Free Mode using the slider in the bottom-left of the app screen. 
  5. Select Door Limits from the menu.
  6. Open the door fully and then press OK.
  7. Close the door fully and then press OK again.
  8. Press OK again to return to the menu.
Idea
To continue auto-calibrating from this point, follow the steps in this article.

Info
This article applies to the following products: 
 DWSR102U
 DWPS102U