How to add a transmitter to an XPL receiver

How do I add a transmitter to an XPL receiver?



To add a transmitter to the memory of a CDVI XPL receiver, follow these simple steps: 
  1. To add a transmitter, press and hold the P1 button to enter the menu.
  2. Once you have entered the menu, release P1 and then press it again to enter the memory.
  3. Press P1 a third time to select Relay 1. The receiver then waits for the transmitter button to be pressed.
  4. Press the button on the transmitter.
  5. Once registered, use the P2 button to scroll down and exit the memory. Press P1 to confirm and exit.
  6. Once back in the menu, scroll again using P2 to exit the menu. Press P1 to confirm and exit.
  7. Finally, press the transmitter button to test and check the receiver has memorised it.
If you see the message  >>>RF<<<  this indicates that the transmitter has not been recognised by the receiver. 

Do you need to learn how to delete a transmitter from the receiver memory?


    • Related Articles

    • How do I delete a transmitter from an XPL receiver?

      To delete a transmitter from the memory of a CDVI XPL receiver, simply follow these steps:  Press and hold the P1 button to enter the menu. Scroll down using P2 until you reach Delete. Then press P1 to confirm your selection. In the Delete menu, ...

    • How do I erase all transmitters on a Z Series receiver?

      To erase all the transmitters memorised on a Z Series receiver, follow these steps:  Press P1 until the red LED on DL1 shows. Then release P1,  and press again and hold until both the red and green LEDs flash three times.  The unit is then fully ...

    • How do I add a card or tag to my ATRIUM installation from the reader?

      To register a new access credential (card/tag) on your ATRIUM system, follow these steps:  First, open the ATRIUM web portal on your device. Then, hold the credential you wish to add up to the installed reader. The reader will not recognise the ...

    • Managing access levels in the ATRIUM software

      Introduction Access levels determine which areas in the building a user will have access to and during which schedules. This is done by enabling the access level and then assigning a schedule to each area. In order to define access levels, you must ...

    • How do I add & assign an Access Level using the web server?

      To learn how to add and assign an Access Level using the ATRIUM web server, watch this short video.