DIGIWAY Spring Return
DIGIWAY Plus normal operation troubleshooting
The door isn't operating when triggered Check the door's operation by using the direct open command. Make sure you exit the menu then use the bottom button to immediately trigger an open command. Alternatively, use the radio fob (once it has been ...
DIGIWAY Plus auto-calibration troubleshooting
General advice for setting up Fit the unit and arm as per the diagrams in the installation manual. The door must be completely free swinging with a physically defined close point - i.e. not a swing-through door. To begin with, keep the setup as basic ...
DIGIWAY Spring Return normal operation troubleshooting
The door isn't operating when triggered Check the door's operation by using the direct open command. Make sure you exit the menu then use the bottom button to immediately trigger an open command. Alternatively, use the radio fob (once it has been ...
DIGIWAY Spring Return auto-calibration troubleshooting
General advice for setting up Fit the unit and arm as per the diagrams in the installation manual. The door must be completely free swinging with a physically defined close point - i.e. not a swing-through door. Any hydraulic or spring closing/hold ...
Can the DIGIWAY Spring Return be connected to a fire alarm?
Yes. Terminals 3-4 require a closed contact - when that contact goes open, the DIGIWAY Spring Return will go into Fire Mode (if set up in the settings).
Can transmitters be used to operate the DIGIWAY Spring Return?
Yes. The DIGIWAY Spring Return comes with a built-in radio receiver inside the operator. Any of CDVI's TX26 range of transmitters can be added into the memory to activate the unit. The maximum number of transmitters that can be added to the ...
Can the DIGIWAY Spring Return work in wind-affected areas?
In windy or draughty areas, the door operator can be made to close more firmly or faster. This is achieved by applying extra spring tension and/or reducing motor breaking. This will increase the closing speeds set in the Main Functions menu (V3S and ...
Does the DIGIWAY Spring Return have an extended arm kit?
The sliding arm is a standard size to fit the parameters given for the install. There are extensions available for the articulated arm. There are also shaft extensions available if the unit needs to be mounted higher than a typical installation to ...
What power does the DIGIWAY Spring Return require?
All DIGIWAY door operators, including the DIGIWAY Spring Return, are mains powered.
Does the DIGIWAY Spring Return have battery backup?
There is no battery backup for the DIGIWAY Spring Return. In the event of a power failure, the operator will work as a typical spring closer unless the power is provided by an uninterrupted power supply.
Does the DIGIWAY Spring Return hold the door locked?
The DIGIWAY SR door operator does not hold the door locked. It provides 12Vdc 1A and a full relay through which you can incorporate an electronic lock.
Can the DIGIWAY Spring Return be used manually?
The DIGIWAY Spring Return is usually in semi-automatic mode. This means it works as: Power open (when triggered to open) OR manually push open THEN spring close. If users push through the door, it puts tension on the spring mechanism and does not ...