Which ievo Interface Boards can be used on which sites?

If you have a site with existing REV3 equipment and the requirement is to add more ievo readers, they must use REV4S boards (IEVO-MB08K). 

REV4 boards (IEVO-MB10k or IEVO-MB50K) CANNOT be used.

Brand new installations will only use the REV4 boards. 

If you are replacing a REV3 reader or board, please contact sales to verify the requirements.

Contact us at sales@cdvi.co.uk or +44 (0) 1628 531 300.

• Related Articles

• Can the ievo fingerprint reader heads be used without the Interface Board?

  No. The Interface Board provides the brains and the power for the reader head. The Interface Board should be installed on the secure side of the door, in order to keep the fingerprint template data contained on it secure. The reader head cannot be ...

• I have added a new Interface Board to the system, but registered fingerprints aren't being recognised.

  A new Interface Board will not automatically download the existing fingerprint database from the other boards. You will need to back up the database of an existing board using the ievo network tool, and then restore it to the new board. All the ...

• What is the default IP address of an ievo Interface Board?

  The default IP address of any ievo Interface Board (part codes beginning IEVO-MB) is: 192.168.1.225

• What type of cable do I need to connect the reader head to the Interface Board?

  Every ievo fingerprint reader connects to the Interface Board via a bespoke PoE (Power over Ethernet) connection. The PoE connection carries both power and data. Therefore, high-quality shielded Ethernet cable should be used for this connection in ...

• Can ievo readers be used as a standalone system?

  Yes. ievo fingerprint readers can be attached to a Wiegand relay converter. This allows a single door to be unlocked with no events. You will still need an ievo Interface Board to run the system as a standalone solution.