What is the maximum cable length for the network connection?

The maximum recommended length for an Ethernet cable is 100 metres.

According to the Ethernet standard, you can also use an extender if required.

We recommend using CAT6 or CAT6e Ethernet cables to power Robin intercoms and ensure optimal performance and future-proofing.

• Related Articles

• What type of cable should I use and how far can I extend them?

  This article covers cabling requirements and limits for ievo biometric fingerprint readers. First check which Revision of ievo equipment you are using - it will be either REV3 or REV4. Revision 3 (REV3) Equipment REV3 ievo readers come supplied with ...

• What type of cable do I need to connect the reader head to the Interface Board?

  Every ievo fingerprint reader connects to the Interface Board via a bespoke PoE (Power over Ethernet) connection. The PoE connection carries both power and data. Therefore, high-quality shielded Ethernet cable should be used for this connection in ...

• What type of cable is required for Robin intercoms?

  Robin intercoms require a network cable for operation. The devices are powered by PoE (Power over Ethernet) and require network connectivity to operate. PoE can be supplied either via a PoE switch or with mains power and a separate PoE injector. The ...

• Using the system overview in the ATRIUM software

  Introduction The System Overview displays and allows management of all ATRIUM modules within the access control system. From the System Overview it is possible to see and control the inputs, outputs, readers, doors, areas, door locks, relays, bell ...

• Is installing a network cable worth the effort?

  We hear this question a lot. Not all buildings, particularly residential homes, are set up with Ethernet cables or ports in the correct locations for intercom systems. However, a wired intercom ensures long-term reliability and the best possible ...