How do I connect the DWSSS-5M1 safety sensor to the DIGIWAY door operator?

DWSSS-5M1 is an infrared safety sensor for use with DIGIWAY door automation. It can be used with both the DIGIWAY PLUS and DIGIWAY SR door operators, and is suitable for both indoor and outdoor installation.

Download this guide to learn more about how to connect and set up the DWSSS-5M1 safely, for a successful installation every time. 

• Related Articles

• DIGIWAY Plus normal operation troubleshooting

  The door isn't operating when triggered Check the door's operation by using the direct open command. Make sure you exit the menu then use the bottom button to immediately trigger an open command. Alternatively, use the radio fob (once it has been ...

• DIGIWAY Plus auto-calibration troubleshooting

  General advice for setting up Fit the unit and arm as per the diagrams in the installation manual. The door must be completely free swinging with a physically defined close point - i.e. not a swing-through door. To begin with, keep the setup as basic ...

• Can DIGIWAY door operators be mounted on the door?

  No. Both the DIGIWAY Plus and the DIGIWAY SR must be mounted on the frame above the door. Do not mount the door operator on the door leaf itself.

• Does the DIGIWAY Plus hold the door locked?

  No. The DIGIWAY Plus door operator does not hold the door locked. An electronic lock is incorporated for this purpose.

• Can the DIGIWAY Plus work in wind-affected areas?

  As the DIGIWAY Plus is power-open and power-close, installation in windy or draughty areas will need to be carefully considered. The unit would need to be set up with strong forces to overcome any wind effect. In addition, the obstacle detection ...