How do I add fobs from new to a Promi500/DGPROX

How do I add fobs from new to a Promi500/DGPROX

Enter 12345 twice to enter programming mode.

Enter *0 01 for fob use only,
Enter *1 and lock time required in 2 digits, for example 05 would be 5 seconds and 10 would be 10 second.
Enter location 000, LED will show green for an unused location, present fob to DGPROX and LED will change to orange.
Enter 001 and repeat as above, continue until all fobs have been added.
Press # to exit programming.

To add further fobs:
Enter 12345 twice (or master code if changed)
Enter next available location and containe as above.

Note: we recommend to make a note of the fob number, the location entered and the user the fob is issued to, this will allow the fob to be deleted if lost or the user leaves the company.

    • Related Articles

    • How do I add a card or tag to my ATRIUM installation from the reader?

      To register a new access credential (card/tag) on your ATRIUM system, follow these steps:  First, open the ATRIUM web portal on your device. Then, hold the credential you wish to add up to the installed reader. The reader will not recognise the ...

    • How do I add a card and assign it to a user?

      To learn how to add a card to ATRIUM and assign it to a user using the web portal, watch this short video. 

    • Managing credentials in the ATRIUM software

      Introduction This section allows you to define details pertaining to access cards and credentials. Cards may be associated to a user directly from the Card Properties window while defining the card, or later from either the Card Properties or User ...

    • Adding a PIN code and Tags/cards to a Promi500/DGPROX

      To add a PIN code to a Promi500 or DGPROX first make sure the unit is set to PIN & Proximity (*0 00) or PIN or Proximity (*0 02) . A tag must be added in the location first, then instead of confirming the tag with a * enter a 5 digit pin code, then ...

    • How to enroll a face in standalone mode

      This article details how to add users and enrol face template to their profile on the iface™ facial recognition terminal when it is in standalone mode. If your iface is part of a networked access control system, you will need to enrol users via the ...