Does the DIGIWAY Spring Return have an extended arm kit?

The sliding arm is a standard size to fit the parameters given for the install.

There are extensions available for the articulated arm.

There are also shaft extensions available if the unit needs to be mounted higher than a typical installation to clear a wide architrave/frame.

See all the DIGIWAY accessories on the CDVI website. 

• Related Articles

• DIGIWAY Spring Return auto-calibration troubleshooting

  General advice for setting up Fit the unit and arm as per the diagrams in the installation manual. The door must be completely free swinging with a physically defined close point - i.e. not a swing-through door. Any hydraulic or spring closing/hold ...

• DIGIWAY Spring Return normal operation troubleshooting

  The door isn't operating when triggered Check the door's operation by using the direct open command. Make sure you exit the menu then use the bottom button to immediately trigger an open command. Alternatively, use the radio fob (once it has been ...

• Does the DIGIWAY Plus have an extended arm kit?

  No. The DIGIWAY Plus arm is a standard size to fit the parameters given for the installation. There are shaft extensions available if the unit needs to be mounted higher than typical. See DIGIWAY shaft extensions range

• Does the DIGIWAY Spring Return hold the door locked?

  The DIGIWAY SR door operator does not hold the door locked. It provides 12Vdc 1A and a full relay through which you can incorporate an electronic lock.

• Can the DIGIWAY Spring Return be used manually?

  The DIGIWAY Spring Return is usually in semi-automatic mode. This means it works as: Power open (when triggered to open) OR manually push open THEN spring close. If users push through the door, it puts tension on the spring mechanism and does not ...