Do I need additional wiring for a door lock?

Yes.

An additional two-wire cable is required to connect an electronic door lock to the intercom. 

The intercom is powered by PoE (Power over Ethernet). The intercom does not supply power to an electronic lock. In order to connect an electronic lock, you will also need an additional power supply for the lock. 

• Related Articles

• DIGIWAY Spring Return normal operation troubleshooting

  The door isn't operating when triggered Check the door's operation by using the direct open command. Make sure you exit the menu then use the bottom button to immediately trigger an open command. Alternatively, use the radio fob (once it has been ...

• If I need an extra monitor additional to what's included in my kit, will I need anything else?

  Yes, you will. Ask your installer for further guidance on what you'll need.  Most 2EASY kits have a CDV-PS1 included. In this case, to add an extra monitor you will need to replace this with a CDV-PS5. If your kit came with a CDV-PS6, you can add up ...

• How do I set the door limits?

  To correctly auto-calibrate the DIGIWAY, first you need to set the spring pre-load tension. For instructions for the full calibration process, see this article. Once the spring pre-load tension is set, you can set the door limits by following these ...

• Can I add an extra door station?

  Yes, you can! You can have up to 4 door stations on any 2EASY system. Adding extra door stations will also require some additional units in the electronics to keep everything running smoothly. Ask your installer about a CDV-DBC4A and about the cable ...

• Does the DIGIWAY Plus hold the door locked?

  No The DIGIWAY Plus door operator does not hold the door locked. An electronic lock is incorporated for this purpose. This article applies to the following product: DWPS102U