Can transmitters be used to operate the DIGIWAY Plus?

Can transmitters be used to operate the DIGIWAY Plus?

Yes.

The DIGIWAY Plus has a built-in radio receiver.

Any of the TX26 range of transmitters can be added into the memory to activate the unit. The maximum number of transmitters that can be added is 50 (including the master). The master is the first transmitter added (usually the transmitter included with the operator) and allows access to the menus. It is designed to make setting and configuring parameters easier.
We do not recommended that installers give the master transmitter to the end user. They may inadvertently change settings or parameters that affect the operation of the door, making it unsafe. Only the master transmitter can be used to change settings - all other transmitters only trigger the operation of the door. 




    • Related Articles

    • Can transmitters be used to operate the DIGIWAY Spring Return?

      Yes. The DIGIWAY Spring Return comes with a built-in radio receiver inside the operator. Any of CDVI's TX26 range of transmitters can be added into the memory to activate the unit. The maximum number of transmitters that can be added to the ...

    • Can request-to-exit buttons be made wireless to operate DIGIWAY door operators?

      Yes. The DIGIWAY Spring Return has a built-in radio receiver. To make a request-to-exit button wireless, you will need a TX26-MC1 transmitter. The transmitter requires a 9V battery and can be used to convert any request-to-exit button with Normally ...

    • DIGIWAY Plus normal operation troubleshooting

      The door isn't operating when triggered Check the door's operation by using the direct open command. Make sure you exit the menu then use the bottom button to immediately trigger an open command. Alternatively, use the radio fob (once it has been ...

    • Can the DIGIWAY Plus be used manually?

      No. The DIGIWAY Plus is a fully automatic door operator for swing doors. This means it powers open and powers closed. The door should not be used manually. If the door is required to be used manually, then the DIGIWAY Spring Return door operator ...

    • DIGIWAY Plus auto-calibration troubleshooting

      General advice for setting up Fit the unit and arm as per the diagrams in the installation manual. The door must be completely free swinging with a physically defined close point - i.e. not a swing-through door. To begin with, keep the setup as basic ...