Can the DIGIWAY Spring Return be connected to a fire alarm?

Can the DIGIWAY Spring Return be connected to a fire alarm?

Yes.

Terminals 3-4 require a closed contact - when that contact goes open, the DIGIWAY Spring Return will go into Fire Mode (if set up in the settings).



    • Related Articles

    • Can the DIGIWAY Plus be connected to a fire alarm?

      Yes. Terminals 3-4 require 24Vdc, and when this is dropped by the fire alarm system the DIGIWAY Plus will go into Fire Mode (if set up in the settings). Consult the DIGIWAY Plus installation manual for more information about connecting to fire ...

    • DIGIWAY Spring Return auto-calibration troubleshooting

      General advice for setting up Fit the unit and arm as per the diagrams in the installation manual. The door must be completely free swinging with a physically defined close point - i.e. not a swing-through door. Any hydraulic or spring closing/hold ...

    • DIGIWAY Spring Return normal operation troubleshooting

      The door isn't operating when triggered Check the door's operation by using the direct open command. Make sure you exit the menu then use the bottom button to immediately trigger an open command. Alternatively, use the radio fob (once it has been ...

    • Can the DIGIWAY Spring Return be used manually?

      The DIGIWAY Spring Return is usually in semi-automatic mode. This means it works as: Power open (when triggered to open) OR manually push open THEN spring close. If users push through the door, it puts tension on the spring mechanism and does not ...

    • DIGIWAY Plus auto-calibration troubleshooting

      General advice for setting up Fit the unit and arm as per the diagrams in the installation manual. The door must be completely free swinging with a physically defined close point - i.e. not a swing-through door. To begin with, keep the setup as basic ...